PDA

View Full Version : A "Shout Out" to Buckshot


Maven
10-01-2009, 06:44 PM
Our own Buckshot has an article on modifying Lee 6 cavity molds in the new (#201) "Fouling Shot." Good job, Rick!
Catshooter
10-01-2009, 08:32 PM
Right on! I'll be looking for it. Way to go Rick.


Cat
scrapcan
10-02-2009, 02:27 PM
Just read the article at lunch and was going to post about it and saw Maven's post.

Good going Rick.
Johnch
10-02-2009, 07:37 PM
Just another case of the Cream rising to the top

About time he for one is reconised for his skill and knowlage

John
Buckshot
10-03-2009, 01:51 AM
..............Ha! I'd sent that article in 3 years ago and had totally forgotten about it. I was sitting at the reloading bench glancing through the magazine after pulling it out of the mailbox. When I first saw the article I didn't recognize my own name :-)

..............Buckshot
Maven
10-03-2009, 09:27 AM
"Ha! I'd sent that article in 3 years ago and had totally forgotten about it."

Apparently Glenn Latham (FS editor) did too! I've been accustomed to waiting 6 - 8 months for one of my articles to be published, but 3 yrs. is a bit over the top.
PatMarlin
10-04-2009, 11:07 AM
My cousin... he's famous ...:holysheep :bigsmyl2:
MT Gianni
10-04-2009, 03:41 PM
Always was famous here Pat.
PatMarlin
10-05-2009, 12:10 PM
Always was famous here Pat.

-and now he's gone world wide ...:cbpour:
Bad Water Bill
10-07-2009, 09:50 PM
With all this notoriety will we have to call him MR BUCKSHOT from now on?
Buckshot
10-08-2009, 01:04 AM
With all this notoriety will we have to call him MR BUCKSHOT from now on?

...........Better not!!! :-)

..............Buckshot