New HP for 360180 NOE

[Blammer]

Ok, it's new to me.

Visited a friend yesterday and used his machinery to make a HP pin for my 360180 NOE mould.

It's an old idea on the design but I just wanted to try it out.

Next will come the water jug hunting safari, with luck I may get 3 or 4 lined up for one shot... :)

http://i54.photobucket.com/albums/g81/blammer8mm/Cast%20boolits%20fun/DSCN7691.jpg

It's a "dish" design, looks like you took a drillbit and just ran it into the boolit and stopped just before the straight shank started diggin in.

[2Tite]

2 comments.................looks like the point needs a little polishing and your friend might need a double handful of those at some point.......................

[Blammer]

lol

not a problem, first I'll have to clean the mould so I can get some really good lookin boolits cast.

[Blammer]

Ok, sized and load a few up in my Win 94 in 360 Dan wesson.

sized lubed checked wt was 185gr.
ww alloy air cooled

need to check velocity...

15gr of Lilgun and my 24" brl.

First jug, destroyed, second clearly blown up well, third, punched hole in, fourth dented the back of the water jug and boolit was recoverd.

Recovered wt with all the pieces was 150gr.
GC stayed on. :)

http://i54.photobucket.com/albums/g81/blammer8mm/Cast%20boolits%20fun/DSCN7697.jpg

[Blammer]

Not nearly as destructive as the deeper "standard" hollow point.

the shank left was much bigger than on the std hp tested earlier.