94AE ejector roll pin

[Ekalb2000]

Was playing with the gun. And I cycled the lever and out came the ejector. Took it insied and disassymbled it and noticed the roll pin was gone. Done a search but no luck.
Soo.. do any of you know a place that i could get one the proper size. Heck if someone has one apart could they mic it for length and width. Then I could see what I have on hand.
Thanks
andy

[Jon K]

Try your local hardware store/auto parts for the roll pin.
Are you sure that's all you need? Usually when the pin falls out, it's because the ejector broke. Numrich has ejector & spring.

Jon

[pietro]

I would upgrade the rifle by replacing the departed roll pin with a solid pin - made by inserting drill bit shanks until the proper diameter is found, or a bit over if there's no exact match, run the bit through there to true everything up, then grind off the fluted end of the bit to use the shank as the new pin.

.

[Ekalb2000]

Went to Ace and they had some solid pins. They were a little big. Chucked it in the drill and with som 100 grit the 400 grit got it to the rite size. After hammering it in I then took the dremmel to what was left over. It aint going now where.
Thaks for the idea pietro.