More Pics 43 Spanish mold done.

[Marvin S]

I finished the mold and run some boolits just a few minutes ago. I weighed one since the sprue plate was installed @ 350.5 so my target of 370gr was pretty close. I also received the Lyman mold tonight and ran some with it also. I think the only thing better on the Lyman is the interior finish. Mine was more concentric and better size, so Im pretty happy with it. Thanks for lookin.

[Catshooter]

Nice work Marvin.


Cat

[357maximum]

Very nice :drinks:

are you left handed?

[Marvin S]

Yea Left handed, very observant.

[Freebore]

Good work Marvin! I am observant too. I was able to see this mold being made and when the sprue plate was installed I visualizes myself trying to manipulate it, with me being a right handed type, It would be difficult! Good luck with your Rolling Block project.

[357maximum]

Yea Left handed, very observant.

I could see how much time and effort you put into that beautiful mould....I did not believe for a minute you made it backwards on accident.[smilie=1:

[lead-1]

Very nice work.

[Marvin S]

Thanks guys. I sized some boolits last night after making a couple Lee type push through type dies and a ram punch out of 4130 round stk. To start I made a .440 which should chamber with no problems and a .443 which will not.

[smokemjoe]

Great job. PM sent. JOe