Before I do this..Lee seating stem

[daboone]

I use the Lee 9mm seating die for both FMJ and my TL356-124-TC. I've read several threads for using epoxy and other fixes for non RN designs. My OALs are more consistent with the epoxy fix.

I'd like opinions about this idea. I sized down slug to snugly fit in the seater. (I also cut it down to about 1/4 inch long.) Dropped it in and put the stem back and adjusted it to the OAL I wanted. It seems to work but you folks might see a problem I don't. ????? It would be easier than removing the epoxy each time I switch.

[woodsoup]

Probably easier in the long run to purchase another plug from lee. Send them a bullet and they'll send you back a plug for that bullet. Or just get a stock plug and use it for RN and the epoxied one for your TC's.

[pdawg_shooter]

I used hot glue, works fine and easy to change. Just warm with a heat gun and press in another bullet to configure.