borderghost
04-07-2009, 08:47 PM
I have just ordered a custom 3 cavity mould , the bullet will be .451 / .835 long / smooth body / 325grns / flat base/ RN , also a jig of my own design to make hollow points after i cast the bullets , hollow point will be 3/16" and depth will be adjustable - will be shooting this bullet in a sabot , gun will be a 50cal long rangehunter , anyone have ideas on the lead , i think that i want it to be medium hardness , but at the same time want the expansion factor also , went to smooth body , hoping it will release from the sabot better , mould is to be made from brass , any reply would be welcome , good or bad .