Mihec 30 cal.

[arcticbreeze]

Mihec and others,

I would like to propose a future buy to you and others. I think you mentioned at one time you can do multi cavity non hollow point molds. I would like a copy of The Ranch Dog TLC311165 but with standard lube grove(s) in maybe a 2 cavity iron mold. I love the design but hate TL boolits. I would like to know if it is possible and if there would be interest enough to do it?

[arcticbreeze]

Another thought,

Could the same cherry be used to make the same boolit but opened to .323 and .356?

Please forgive me if this doesn’t make sense because I am definitely no machinist.

[MiHec]

I will check this out...

About cherry - on CNC can be opened to different diameters but profile stays the same (and with "removed" 3° draft)


Miha

[Ranch Dog]

Greetings guys, I just wanted to add a note that articbreeze contacted me about his proposed buy and it is fine by me. In that I will not be involved in the redrawing to his spec, please funnel all communication about this buy and the bullet to him.

Some advice, scaling a bullet up does not work. Each bullet should meet specific throat/leade requirements for the "target" cartridge.

[mike in co]

ok...i do not know why anyone would want a custom 2 cav instead of a 6 cav. sorry but i will not spend money on a 2 cav non-hp mold.

mike in co

[arcticbreeze]

The reason I said 2 cavities was because I prefer iron and six cavities would be heavy but I would not be opposed to 3 or 4 in iron.

[runfiverun]

you have to make slight changes when going up and down in size.
the lead angles change.
a good design with tweaks does prove out though.
i would be interested in what rifle you are thinking of using the redesigned rd boolit in?
a marlin or a bolt?