View Full Version : Lee mold 90413 ?
01-26-2006, 09:04 PM
I have a Lee mold #90413 .It is plain based ,one grease groove and a long swc nose. It looks a lot like the 90316 or 90470 bullet. I measured the cavity and got .435". not a 44 nor a 45! It looks like a "target" bullet I shot in the .45 acp when in the service in the 60's.
01-26-2006, 09:45 PM
That should be about perfect for most 44 mag revolvers. Might have to size it down a couple .000" Its lots easier to size em down than up.
01-28-2006, 04:29 PM
:rolleyes: Welll ! I cast a few if these up( couldn't stand the suspense) and found out they are .454 dia and weigh 161 grains.I thought they looked familiar. Now I gotta find a nice load for them .
Powered by vBulletin® Version 4.2.1 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.