View Full Version : Does anyone still make the priming slide for a Ideal #10?
02-14-2009, 12:38 PM
I have an Ideal #10 tong tool in .45ACP and its missing the priming slide for it. Im wondering if they still make these or if anyone knows where to get one? I dont care if its new or used and I just want to make it a complete tool again. Any help would be appreciated. Thanks, Mike
02-14-2009, 03:43 PM
I would check the Antique Reloading Tool Collectors Association. Our old friend Floodgate is there and they should be able to help.
02-14-2009, 08:05 PM
Mike check this one out.
02-15-2009, 07:31 PM
Hello Ken and thanks but im looking for the slide plate that holds the case in the handle for priming. Its the small blued flat plate on the under side of the handle.
Thanks Bret, I sure do miss Floodgate here and I will e-mail him and see what he says. I still gotta get some old info to him anyway so may as well kill two birds at once.
02-19-2009, 07:12 PM
The 310 shop has parts, sets, dies, pretty much whatever you need to get your 310 tool up and running.
Powered by vBulletin® Version 4.2.1 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.