224 22lr boolit pics

[Jjed]

Here are some of the boolits I have made with my corbin setup,
Also have a 303 brit die I damaged, had my brother in-law bore it out to make lead wire for core's but it's too much for my rcbs, trying to find a 7/8x14 threaded piece to weld to a hydraulic setup using a bottle jack. Any ideas would be appreciated.

From the left 53 gr hp 68 gr sp 73 gr sp
Using cci cases
Sorry for the poor pic’s best I could do.



[

[wonderwolf]

I can't tell if those are all the same ogive or not? What ogive are they? I have a #6 on its way (soon I hope) did you trim the cases down at all?

[Jjed]

Not sure what ogive they are, I bought this die set a piece at a time about 20 years ago (had small children and no money). Checked the die and can find no markings on the point-forming die, I just don't run the heavier boolits in the point forming die as far as the lighter ones. did not trim.

[kawalekm]

Those are very good looking! Here are some 55 grain hollow points I made with SportFlite dies.
http://i141.photobucket.com/albums/r55/kawalekm/Swaged22bullet.jpg

[Jjed]

Do you have two different point forming die's?
realy like that soft point, I can never make mine that nice.