View Full Version : WTB 0.251-0.500'' Steel Pin Gage Set Minus
ohiochuck
02-01-2021, 11:13 PM
Would like to buy a set of steel pin gages to measure the cylinders and chambers of my revolvers .32/.38/.44/.45
Thanks!
Jim
Wolfram Malukker
02-01-2021, 11:39 PM
May have a set here. Have to double check to see if my spare set is a + set or a - set.
DougGuy
02-01-2021, 11:51 PM
You need the half thou sizes as well, .001" increments are too coarse to measure accurately. Get the .0002" under minus set.
I just looked on the bay and there is a NuLine set .2515" .5005"
and just below it a minus set .0251" .500"
both sets under $90 each. That's not bad at all. The first one has a mistake in the shipping which I have emailed the seller to inform them, and I informed him that he does not list if his set is minus or plus, and what tolerance it is.
I use pin gage set as my search criteria, then click on used in the filters over to the left. You will find what you need here. I use both sets daily, could NOT do cylinder and barrel work without the half thousandths set.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.