Gotta give Lee a positive!

[madcaster]

I broke the arm that goes between the sprue plate and the wooden handle on a 6 cavity.
I sent them an email and got it yesterday.
THANKS LEE!!!
Lesson learned-use mould release!

[Maven]

madcaster, I had the same problem and Lee fixed quickly and at no cost to me. The way to avoid a recurrence of this is to gradually bring the mold up to temperature by filling only a few cavities at a time and progressing one additional cavity (front -> rear or vice versa) until you get perfect CB's.

[mooman76]

Several times I have broken thinks on my Lee dies. Decapping pin and I had brass with a flash hole that was so tight it actually was pulling the pin out. I sent them to Lee and had them replaced for free both times and only took a week no questions asked.