WTB- Pan lube Kake cutter in .356

[Ohio Rusty]

I knew this day would come. I'm finally getting around to loading .380's as 1) .380 prices have gone through the roof 2) .380's are more difficult to find as of late 3) I bought a bersa combat model. I have the Lee 102 grain mould and the Lyman 358242 92 grain boolit. I have a Lee sizer in .356. I have always pan lubed so now I'm needing a Kake Kutter to cut the sized boolits out of the lube. Any idea if anyone on the list is still making them ??

Ohio Rusty ><>

[HARRYMPOPE]

I have a kake kutter in 358.

264076

[abunaitoo]

I have a Lee kit in .357

[BrassMagnet]

There used to be a seller on FleaBay that made them. They seemed OK, but I have never gotten around to using a cake cutter.
You can make your own by drilling out or reaming from the case head a 9MM, 9MM Super, etc, or even a 38 Spl that has been neck sized with a 9MM die.

[SSGOldfart]

There used to be a seller on FleaBay that made them. They seemed OK, but I have never gotten around to using a cake cutter.
You can make your own by drilling out or reaming from the case head a 9MM, 9MM Super, etc, or even a 38 Spl that has been neck sized with a 9MM die.

Yep try searching for "Bob's lube" on eBay or fleabay as we call it. He sells pan lube kits as well as just the make cutters.

[fgd135]

I don't use a Kake Kutter; I let the lube cool in the pan with the boolits for a few minutes in my freezer, remove the lube cake from the pan, and simply push the boolits thru the lube cake with a thumb. Works like magic.

[oley55]

I don't use a Kake Kutter; I let the lube cool in the pan with the boolits for a few minutes in my freezer, remove the lube cake from the pan, and simply push the boolits thru the lube cake with a thumb. Works like magic.

unless you are using Ben's Red or similar lube recipe, then it is too soft/sticky for the push method. In my experience...

[redneck1]

So did you find a cake cutter ?
If not send a pm and I'll make you one