WTB/WTT - Need a Couple Single Cavity Mold Parts

[Jkrem]

Help. I’m the new owner of a little old Ohaus single cavity 45-200-S mold which is in need of a sprue plate and sprue plate screw. I pulled a plate off of a Lyman mold and scrounged a screw with the correct thread size just in order to see how the old girl would work. Ends up the bullets are fantastic, so I’d like to put this back in service. So, if you have an extra usable sprue plate and proper screw that might fit a small single cavity Ohaus mold, I’d like to hear from you. I’d probably even try some rusty parts, provided they are restorable. Any pack rats out there?

[Pressman]

Lyman made the Ohaus moulds so Lyman parts should work.

[10mmShooter]

Midway, Lyman single cavity rebuild kit about 10 bucks

[Jkrem]

Thank you. Unfortunately the sprue plate screw is a different thread size (at least my mold is). Additionally the Lyman single cavity rebuild kit is for large molds. Thus, my search for used parts...


Lyman made the Ohaus moulds so Lyman parts should work.

[floydboy]

I watch ebay for old junk molds that go cheap. Salvage the sprue plate and screws and relist the blocks. In the end you get the parts you need for very little.

[Jkrem]

Please close.