gbrown
02-14-2019, 12:51 PM
Close Thread. Funds received, sold.
Press I picked up a few months ago. Hunk of gunk and rust. Cleaned up nicely. Works smoothly. Without handle in, park the ram at the top, touch the pivot point and the ram/die holder drops to the bottom position. Has the original shell holder component with clip in it. Good addition to your bench. No room on mine. I lubed it a little, but you may want to do more. Also, just for those that may not be familiar with this model, die holder top and shellholder plates are cast/machined aluminum.
Some assembly will be required as the handle is to long to ship mounted. Just drift the pin through the cam over to the left, drop in the handle and line the holes up and drift the pin to the right. $60.00. Shipping is going to be $20, as I can ship it in a large flat rate. I will do any payment method you prefer.
235981235982235983
Press I picked up a few months ago. Hunk of gunk and rust. Cleaned up nicely. Works smoothly. Without handle in, park the ram at the top, touch the pivot point and the ram/die holder drops to the bottom position. Has the original shell holder component with clip in it. Good addition to your bench. No room on mine. I lubed it a little, but you may want to do more. Also, just for those that may not be familiar with this model, die holder top and shellholder plates are cast/machined aluminum.
Some assembly will be required as the handle is to long to ship mounted. Just drift the pin through the cam over to the left, drop in the handle and line the holes up and drift the pin to the right. $60.00. Shipping is going to be $20, as I can ship it in a large flat rate. I will do any payment method you prefer.
235981235982235983