350gr Pile Driver Light Mould

[bigiron]

What mould should I look for to duplicate the Beartooth 350gr Pile Driver Lite (.460)

[wmitty]

You might want to take a look at NOE's SC450- 350 RF GC . It's a round ogive rather than the truncated cone of the Beartooth but they both have large meplats. Should work for armadillos or whatever you're after.

[pls1911]

Pile driver???
The NEI 458-440-GC is a 440+ grain slug very nearly shaped like a full wad cutter.
The leading edges are rounded a tiny bit, but for a close range hog hammer it's tough to beat.
NEI is Out of Business due to the passing of the machinist/owners. Wife Patti was entertaining reasonable offers on gear and remaining stock.
It might check the website and check into what's left and/or the current status.

[dkf]

Accurate Molds, design 46-350VG is the clone of it. On page 17 of the catalog.

[waco]

^^^^^^^^^This^^^^^^^^^

[MT Chambers]

Veral at LBT kinda wrote the book on these designs/molds.

[white eagle]

I had Tom At Accurate make this
http://www.accuratemolds.com/bullet_detail.php?bullet=46-420C-D.png,
it smashes whitetails out of my guide gun