View Full Version : WTB or WTT need E clips for mp mold hp pins
zymguy
12-20-2018, 08:32 PM
Id like to buy a couple dozen.
Ben
5Shot
12-20-2018, 08:39 PM
Just take the pin to the hardware store and find the size that fits.
You can find them at the local Ace hardware if they carry fasteners. They are metric but I don't remember the size Miha uses. Perhaps someone else can chime in with the size, or send Miha an e-mail.
You can find them at the local Ace hardware if they carry fasteners. They are metric but I don't remember the size Miha uses. Perhaps someone else can chime in with the size, or send Miha an e-mail. I did a search and the size is 3.2mm
jeepyj
12-21-2018, 12:09 PM
IIRC I found mine at Granger a while back. I don't like the way they pop off sometimes.
rancher1913
12-21-2018, 06:26 PM
I only use one per pin. I found that the pin moves in and out better if I only put a clip on one leg of the pin, not both.
thraxx
12-21-2018, 07:50 PM
1/8th is the right size
zymguy
02-07-2019, 08:11 PM
Just in case someone come along later looking for this info I should add I’ve learned the best way to get more e clips. Buy another mp mold ! It comes with more than you really need
Sent from my iPhone using Tapatalk
Just in case someone come along later looking for this info I should add I’ve learned the best way to get more e clips. Buy another mp mold ! It comes with more than you really need
Sent from my iPhone using Tapatalk
I guess that's a cost effective method!:shock:
DocSavage
02-08-2019, 06:45 PM
When I needed e clips at my local hardware store for 5 cents each.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.