View Full Version : WTB, mold and dies
Calamity Jake
10-06-2018, 08:12 PM
for 41 long colt!!!
Any of you other old timers have anything like that your willing to let go of?
Which mold for the 41 colt are you looking for?
smkummer
10-10-2018, 06:28 AM
Before you jump into the delightful challenge of loading for 41 Colt, you should read Harry O’s very useful write up concerning loading 41 colt. Lots of variables. http://harryo.sixshootercommunity.org/
I thought I was going to luck out and get lyman’s Hollow base 386178 mold on eBay for under $100 but it sold in the last seconds for $219! I have both Lyman’s heeled 386177 bullet and the discontinued Rapine hollowbase mold that is close to the Lyman mold.
Which colt revolver are you loading for?
Calamity Jake
10-11-2018, 03:39 PM
It's an SAA
Walks
10-12-2018, 01:36 AM
E-mail Dave Scovill over at HANDLOADER mag.
He has a real love affair with the .41Colt in the SAA
gmsharps
10-12-2018, 08:37 AM
PM Sent on Dies
Calamity Jake
10-12-2018, 02:28 PM
Thanks to gmsharps I have dies, still need a mold.
Calamity Jake
10-13-2018, 04:53 PM
BTT one time
smkummer
10-15-2018, 04:49 PM
Did you decide if you will load hollowbase or heeled bullets? You can load heeled bullets on the long case with a SAA or Bisley.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.