Mould with hollow base for 9mm pistol

[sailor757]

Hi, I'm looking for a mould with hollow base for 9mm pistol. The hollow could be 1-2 millimeters deep or more. Is there such a mould?

(Weight can be anywhere between 120-150 grains.)

[Forrest r]

You might be better off going to the group buy discussions area of this website and ask about a 9mm hb mold.
http://castboolits.gunloads.com/forumdisplay.php?10-Group-Buy-Discussion

Accuracy/bullseye accuracy is new to the 9mm arena. The 9mm's would benifit from a hb swc cast bullet. Decades ago cramer was putting out hb molds. This 45acp hb swc mold made by cramer was not only used for the 1911/45acp's. It did extremely well in the oversized cylinders & bbl's of the 1917 45acp service pistols.
https://i.imgur.com/tVkSHSw.jpg

The mold pictured above casts the hb swc/bottom left in the picture below.
https://i.imgur.com/3f6cvSV.jpg

The 9mm would benefit from such a design seeing how the firearms mfg's put out 9mm's with bbl's from .355" to .359" and twists from 1 in 10 to 1 in 16 inches.