PDA

View Full Version : Missouri Bullet Co.


jlh
03-23-2018, 09:29 PM
Is Missouri Bullet still "good to go?"......If not, who do you recommend?

Thanks
jmort
03-23-2018, 10:19 PM
Yes
Lot of options
Unless I want a gas check I would use them
Beagle333
03-23-2018, 11:30 PM
I like Missouri. I use Oregon Trail too.
Jniedbalski
03-23-2018, 11:40 PM
The bullets I got from them are-very good. About two years ago I think when I got them
rond
03-24-2018, 07:52 AM
The only cast that I buy.
tranders
03-24-2018, 12:06 PM
I have used them quite a bit with good results other than one time got some coated 9mm projectiles that were not coated very well. I ended up tumble lubing them with Alox and used them up.
tomj44
03-24-2018, 12:13 PM
http://www.acmebullet.com/index.php?route=common/home
dverna
03-24-2018, 01:29 PM
Dardas is another good supplier...out of Michigan
kipk49
03-25-2018, 01:23 PM
I purchased a box of .358 wadcutters from them, in 12 BHN. They seem to be well made, although I'm not sure if the coating was properly applied. After the smash test, I could see the coating cracking and coming off in some places.
scattershot
03-25-2018, 05:09 PM
Beautiful bullets, well cast, and packaged very well. Check the diameters, though. I ordered .452, and the ones I have checked so far run .4505-.451. I’d say if you need hard cast bullets, it’s between them and Dardas.
RAK2018
03-25-2018, 07:49 PM
I've bought quite a few pistol boolits from MBC. They worked great.
Pumpkinheaver
03-25-2018, 08:43 PM
Good to go, at least last time I bought some from them.
Uncle Dave
03-26-2018, 02:10 AM
I have used several calibers and styles from them and so far so good. Just be aware of the intended use and purchase the appropriate hardness of bullet to get obturation. They also can custom size -I have read. I have used only the Hi-Tek pistol bullets. I will either cast my own OR buy from them if I don’t have the molds.
Dave