Tip for the day...

[S.R.Custom]

So you lost the cap to your RCBS Uniflow powder throw? Well, the screw on cap from a bottle of Hodgdon powder, when turned upside down, makes a perfect fit. :-D

[copdills]

Great Tip Thanks

[runfiverun]

what.......... i lost my cover???
i'm going to look,,, someones in trouble..
i didn't lose it, i just put it on the messy bench and couldn't see it.

thank for the tip though.

[DLCTEX]

One of mine has a caulk tube for a hopper and a freeze plug (think car engine) for a lid. The calk tube is held in place by, what else? caulk. DALE

[booneh]

the best measure cover imo is a uncle mikes scope cover. the flip up kind. just measure the tube and get one that is a snug fit. i got tired of chasing mine around on the floor. murphy's law says it will end up as far back under something as it can get.
the scope cover stays on. all you have to do is pop it open add powder and snap it shut.

booneh

[Dark Helmet]

+1 on the Uncle Mike's- makes things much easier.

[NVcurmudgeon]

So you lost the cap to your RCBS Uniflow powder throw? Well, the screw on cap from a bottle of Hodgdon powder, when turned upside down, makes a perfect fit. :-D

It sure does, and if you drill a hole in it and install a bolt, you have a handle.

[xyrth]

actually, i use my cap to transition powder from it to the funnel, the nice soft rubber means i don't get stray grains bouncing everywhere.