311467 OAL for 30/40 Krag

[rmcc]

Does anybody have the correct overall length with this bullet in 30/40 Krag? I have a bunch of these I want to plink with. Not going to load them very hot, probably starting load. Given this mold design with so many grooves, I would think pressure would be low.

rmcc

[Bent Ramrod]

The measurement I get is 3.140” overall. I usually single load, but IIRC they do feed through the magazine. Lots of grease grooves showing, so don’t drop them on the ground. :mrgreen:

[rmcc]

Thanks a ton!! That was what I was looking for!! Yes, they do have a lot of grooves!!