WTS Chamber casting alloy

[largom]

I am offering for sale two factory ingots of Cerro Bend alloy for chamber casting. This alloy melts at 158 Deg. If you want to know the true dimensions of your chamber a casting is the only way unless you have the reamer that cut the chamber. There is lots of info available for how to cast a chamber so I will not go into that. This material is reusable after a cast is made. I charged $20 -$25 to cast chambers for customers if they kept the casting, little less if I kept it for reuse. It does not require much material to cast a chamber but I will not melt these ingots into smaller sizes. This alloy sells for $13.00 to $25.00 per lb. Ingots have factory name molded in.

!. Ingot weighs 1 lb. 13 oz. Price is $ 25.00 shipped

2. Ingot weighs 2 lb. 6 oz. Price is $30.00 shipped

Payment by USPS M.O., PayPal + 3% or cash at your risk.
Standard rules, post you take it here then send P.M.
THANKS For Looking, Larry

[pete501]

Do you know the shrink/growth percentage. As I remember Cerro Bend either gains or looses dimensions after it cools.

[largom]

I do not know the percentage. It has been awhile since I used it.

[largom]

#2 ingot SPF
#1 still available

[shortfal]

I'll take that #1
Pete in St Louis

[TCLouis]

According to the directions of old, it is 100% or so 30 minutes after casting.
That is likely somewhat dependent on how good the original casting is

[largom]

Both sold pending funds!
THANKS to all for looking, Larry