View Full Version : need 100gr 32 auto load
08-18-2008, 02:36 PM
does anybody have a load for 32 auto using 100gr RN boolits and accurate #2, #5, or #7? it would really help me out if i didn't have to buy another mold and or powder at the moment. please don't post stiff loads as i'll be using this in a FN 1910.
08-20-2008, 03:30 PM
08-21-2008, 04:38 PM
The only thing I ever loaded other than jacketed bullets was some 77 gr cast lead with 2.2 gr of Red Dot. Worked about like factory hard ball. A 100 gr boolit may be too heavy for the 32 auto.
08-23-2008, 06:11 PM
I got the loads below from another shooter who posted them on another forum. He shoots them with Hornady swaged 90 gr. SWC in a Walther PP. Since I have a PP as well, I tried them all and they worked fine just as he said they would. They worked equally well in my CZ83.
1.7 grains of Bullseye for ~800 fps
2.0 grains of W231 for ~850 fps
2.0 grains of Unique for ~800 fps
2.4 grains of Herco for ~800 fps
08-23-2008, 07:13 PM
That would have been me... I particularly like the Herco loads and have shot thousands of them with complete satisfaction.
Anyway, I saw this thread on the OP's first bump, but didn't reply since I was shooting lighter bullets and didn't use the powders desired.
08-23-2008, 09:10 PM
well by messing with the alloy i managed to get this mold to cast at 95gr. i might be able to get it a little lower. AA# 5 runs a little slower than Herco. so maybe i can run 1.8- 2.0gr #5 behind a 95gr RN? anybody have quickload :) ?
Powered by vBulletin® Version 4.2.1 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.