gator gaz check

[canuck4570]

just received my mold fron NEI for my 500 sw and the gaz check chank is .466 and when I go on the web site punching in gator gaz check it says for the 500 sw pistol the shank should be at max .458 but if I look below it give gaz check for .512 rifle and with shank diamiter of .466.... my question is NEI gaz check are made for these gaz check .466 or the mold was not made wright....thanks Canuck

[Buckshot]

...............What is the OD the 500SW boolit is supposed to drop from the mould?

..............Buckshot

[Bass Ackward]

They can be cut either way. But the .466 will size on better if you need to go a little bigger cause of your throats. Or if you shoot softer mixes. Many times when you hear guys say that hard bullets shoot better, they are really holding the check better after sizing.

[canuck4570]

...............What is the OD the 500SW boolit is supposed to drop from the mould?

..............Buckshot
when casting with wheel weight they come out at .503 and they should be seized at .501 or 502 on the average... but when I measure the gaz check shank they measure .463 so the hornady gaz check are near impossible to put on.... NEI say to me that there shank for the 500 sw are made for gator check...that has a i.d. of .466 so I when and toke a looke at the web site and they say theire gaz check for the 500 sw are .458 I. D. but if you looke below they have some label .512 rifle that have a I.D. of 466.... last night after reading a b it on the cast bullets site I took a 31/64 drill and with the non sharp end tap open the gaz check and now the gaz check fit on easy... but it long work so I guess I will have to wait for the group buy for gator gaz check. in a short sentence the NEI sherry to make the mould where made when
gator made only .466 id gaz check

[canuck4570]

They can be cut either way. But the .466 will size on better if you need to go a little bigger cause of your throats. Or if you shoot softer mixes. Many times when you hear guys say that hard bullets shoot better, they are really holding the check better after sizing.
true on that last night I punch the hornady gaz check with a tapered end of a 31/64 drill and now the fit easy and when I seized the .502 you see that the gaz check is very thight on and I eaven have a hard time taking them of with a pair of plier (experience just to see how hard they wher on)

[Buckshot]

................You don't have to wait for a group buy to get Gator gas checks. Theyre available to anyone, any time.

...............Buckshot

[Blammer]

did you check your other post about this?