View Full Version : Looking for a mold & lube sizer suitable for .316 round nose bullets
Hi all as above.
I have an unconverted J bore Gew88 that has slugged at .316 and I am looking for these bits to get it going.
The issue is that in the UK I cannot get hold of this sizes and I am looking to go the custom route, so I am looking for some help if possible please.
Which brings me to this forum, pleased to meet you all.
Thanks in advance
Reverend Al
04-04-2016, 08:00 PM
NOE are always good folks to deal with and this would likely do the job for what you need ...
http://noebulletmolds.com/NV/product_info.php?cPath=31_266&products_id=1558&osCsid=rc5nr9bv4jefj8n3j56ev08511
If you are using a push through sizing die (to keep things simple) you could always buy a Lee die in a smaller size (for example in a .314") and then polish it out to the size you need. (.316 to .318"?)
http://leeprecision.com/new-lube-size-kit-.314.html
Welcome to this forum by the way ... lots of good folks with lots of great information!
:p
Thanks very much, I think I will do that but get the sizer professionally modded rather than do it myself
Yodogsandman
04-05-2016, 03:44 PM
Buckshot (here on the site) will make non-standard Lee type sizers for you. Great work and great price!
Thanks for the tip regarding buckshot, beforehand I managed to speak to a bloke at Old west bullet moulds, and he has sorted me out a Lee push through modded to .317. Good price including international shipping.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.