Noe Molds

[Tusker]

Does anyone know if Al at NOE is still cutting molds? I have made a few attempts to order, have sent a couple emails, called, but so far have not been able to get a response. The mold i am interested in has not been available for awhile now. Is he still in business? I understand from reading othere threads here that he is a busy man and possibly shorthanded. Is there a secret password or handshake that can get me on the inside with him so he would talk to me and make me a mold?

[Tusker]

Just got an email from Al stating that he will be doing a run of the mold I would like in a month or so. I am looking forward to it.
Thanks Al!

[Hardcast416taylor]

Just for we people on the East Coast that are curious, what mould is it you are interested in?Robert

[Tailhunter]

NOE is shipping for sure. Just got three more.

[Tusker]

Robert, I am interested in the 460-350-gc ranch dog

[5Shot]

He is making molds, but his business model is to make runs of certain molds when there is enough interest. You need to go on his forum and post under the wish list.

[dilly]

Yes, his forum is probably the best place to find him.

[JonB_in_Glencoe]

Posted: 02-22-2016, 01:33 PM

Does anyone know if Al at NOE is still cutting molds? I have made a few attempts to order, have sent a couple emails, called, but so far have not been able to get a response. The mold i am interested in has not been available for awhile now. Is he still in business? I understand from reading othere threads here that he is a busy man and possibly shorthanded. Is there a secret password or handshake that can get me on the inside with him so he would talk to me and make me a mold?
posted: 02-22-2016, 01:47 PM

Just got an email from Al stating that he will be doing a run of the mold I would like in a month or so. I am looking forward to it.
Thanks Al!

14 minutes !!!

Can't beat that [smilie=p:

[Hamish]

For those that read this thread and aren't clued in yet:

http://noebulletmolds.com/NV/


NOE Forums; for general discussion and Group Buys, etc.:

http://www.noebulletmolds.com/smf/

As a general rule, if you can get 10 prospective buyers to put a toe in, Al will make a run.

[Artful]

He was having a delay on getting new cherries cut, but any of his existing designs should be good.

[gwpercle]

Just keep posting and pestering him, took me a few months of nagging and whining but he got around to making some 358-124-TC 4 cavity aluminum moulds for use in 9 mm Luger with gas checks. I would check each week and they were always out of stock Not much demand for GC 9 mm boolit mould , one day 4 were listed in stock, I bought one and there are two still left in stock ! But he did take time , eventually , to fix me up. Be patient , and keep posting.
Gary
The mould was worth the wait.

[Blammer]

I asked for a fly wt 6.5 mould, 57 grains or so.. basically took a 223 and hogged it out. It is a sweet shooter for gallery loads in my 6.5!

got it in a month! and yes it was a special request, so yes he listens so be careful what you ask for you just may get it!