bstone5
04-26-2015, 12:03 AM
Hello All
The attached PDF file is from a CAD drawing of a 100 pound casting pot.
The valve design is copied from a post made in 2009 by another member on this forum.
The container for melting the lead is 8 inch pipe with a 1/4 inch bottom plate.
I may make two of these pots for making alloys for special purposes.
Just another drawing with some thought.
Design is done in Solid Works.
The attached PDF file is from a CAD drawing of a 100 pound casting pot.
The valve design is copied from a post made in 2009 by another member on this forum.
The container for melting the lead is 8 inch pipe with a 1/4 inch bottom plate.
I may make two of these pots for making alloys for special purposes.
Just another drawing with some thought.
Design is done in Solid Works.