Need some "guidance"...

[ShooterAZ]

Mold guidance that is. How are you guys adapting the RCBS Pro Melt guide bar to accommodate the Noe hollow point molds? You know...the ones that have the little bars & screws that wrap around the bottom of the mold to retain the HP pins? This just isn't working out so great for me at the moment.

[RED333]

Remove the bar from the pot, I have a Lee pot that has about the same thing, never did like using it.

[ShooterAZ]

Yeah, I thought about swinging it off to the side and stacking some short 2x4's or something underneath.

[RED333]

I just hold the mold up in the air, sometimes I will rest it on a pan I use to catch the drips.

[plainsman456]

I just put the mold at about a 45deg angle,then slide it across.
It scratches the aluminum molds a bit but it does work...for me.

[Echo]

Make a stage out of 1x4 scrap, and top it with some Al sheet.

[Bigslug]

Rotate bar out of the way. Build a platform.

[Shuz]

Yeah, I thought about swinging it off to the side and stacking some short 2x4's or something underneath.
That's what I do and it works real well.

[ShooterAZ]

I cut and stacked 2 short 2x4's under it. I haven't tried it yet, but it looks like it will work just fine. I will look into wrapping some aluminum flashing around the top 2x4. The problem only occurs with The Noe HP molds, and the really short Lyman 2 cavity molds seem to want to fall off forward of the bar. Thanks for all the replies and suggestions.