Seller/maker of ingot molds

[durango]

A few months back, a member was making ingot molds that fit into SFRB. As I remember, A four ingot mold was about $60.00. I can't find any posts about this person/product--does anyone know who this person is? Thanks for your help. Steve

[jmort]

Phoenix - last I heard he was taking some time off for winter. I got two molds from him very nice. Also got some COWW ingots from him. Good guy.

[durango]

I just reviewed the profile for Phoenix. That particular username doesn't seem to be the guy I'm looking for however, there are 10 or 12 Phoenixs with prefix and suffixes. Can anyone tie him down a little tighter? Steve

[JonB_in_Glencoe]

Beone is the member you are thinking of

He had a post in S&S, I think ? But that would have been deleted when he was done making them.

This is the thread that started that run...the last post in this thread is his.
http://castboolits.gunloads.com/showthread.php?182997-Cast-Boolits-Ingot-Mold/page17&highlight=

[jmort]

No, you are looking for Phoenix. His name is in Red as Vendor sponsor in member list. The ingots are designed for SFRB

[JonB_in_Glencoe]

No, you are looking for Phoenix. His name is on Red as Vendor sponsor in member list. The ingots are designed for SFRB
Well, Phoenix surely could have designed and made ingot molds as well.

See post 184
http://castboolits.gunloads.com/showthread.php?182997-Cast-Boolits-Ingot-Mold&p=2227511&viewfull=1#post2227511
...and then see post 196 for a drawing.
That is the size we finally decided on, so it'd fit into a SFRB.
He made many 4 cav molds, I got two, but still haven't poured Lead them yet.

Post #226 shows photos of the first one being tested
http://castboolits.gunloads.com/showthread.php?182997-Cast-Boolits-Ingot-Mold&p=2241559&viewfull=1#post2241559

[jmort]

I did not realize you all made that design feature as well. So there are, were two. I have two multi-cavity molds from Phoenix that fit SFRB and bought COWW ingots from him which fit the SFRB nicely. Nice to know, thanks