NYBushBro
12-01-2013, 02:51 PM
I have a Mould Master (and also an XX), and would like some info on adjusting/calibrating the thermostat.
I know there is a small screw inside of the shaft that the adjustment knob slides onto; my question is whether one should turn the screw IN or OUT to increase temp.
My Lyman XX has to be my favorite pot to use; however, it doesn't heat up the pot enough for using my MP brass molds (runs around 650ish cranked all the way up).
I know there is a small screw inside of the shaft that the adjustment knob slides onto; my question is whether one should turn the screw IN or OUT to increase temp.
My Lyman XX has to be my favorite pot to use; however, it doesn't heat up the pot enough for using my MP brass molds (runs around 650ish cranked all the way up).