lar45
11-06-2007, 01:31 PM
I got the C502-400 and 477-400KSWC in the other day. While looking them over I noticed that the 502-400 was wobbleing a little on one end. The block was pivoting slightly around the middle.
The male alignment pin wasn't flush with the surface of the mould. I set the mould block on a chunk of steel and used a brass punch to seat the pin in a little farther. It closes tight now with no wiggle. This may be a place to look at for standard Lee-Menting prior to casting?
Other than that, they look good to me.
Thanks for running them.
The male alignment pin wasn't flush with the surface of the mould. I set the mould block on a chunk of steel and used a brass punch to seat the pin in a little farther. It closes tight now with no wiggle. This may be a place to look at for standard Lee-Menting prior to casting?
Other than that, they look good to me.
Thanks for running them.