chinewalk
07-17-2007, 07:40 PM
I know you folks probably are maxed out on Ballisti-Cast, NEI, Mountain molds...etc. for the .500, but RCBS might be willing to expand their mold selection.
I posted the following over at handloads.com...
*******************************************
I've been talking with RCBS quite a bit in the last few weeks about their lack of mold selection in the S&W 500. The frontline customer service folks were fairly insistent that there was no demand for 500 molds.
Today, I finally spoke with one of the fellows that helps drive the mold production and there appears to be an interest in producing a new RCBS 500 mold with a gas check. It will depend on the demand from us. If you are interested in seeing RCBS expand its S&W 500 mold selection, you need to call 800-533-5000 and let them know.
I've also spoken with Lyman and Saeco and they too say they aren't looking to expand their S&W 500 selections due to "no demand". I didn't get by the frontline folks from these companies. No wonder why there is no demand.
I posted the following over at handloads.com...
*******************************************
I've been talking with RCBS quite a bit in the last few weeks about their lack of mold selection in the S&W 500. The frontline customer service folks were fairly insistent that there was no demand for 500 molds.
Today, I finally spoke with one of the fellows that helps drive the mold production and there appears to be an interest in producing a new RCBS 500 mold with a gas check. It will depend on the demand from us. If you are interested in seeing RCBS expand its S&W 500 mold selection, you need to call 800-533-5000 and let them know.
I've also spoken with Lyman and Saeco and they too say they aren't looking to expand their S&W 500 selections due to "no demand". I didn't get by the frontline folks from these companies. No wonder why there is no demand.