View Full Version : Sizing
1maxhunter
12-07-2012, 03:02 AM
still new to the casting. but now new to the sizing also.a .308 180 gr gc being loaded in a .3006 eddystone is any rule of thumb with what size to size to?? my sizer seams to be going about .310 right now. slug and size?? or ??
waksupi
12-07-2012, 03:10 AM
.310 should put you in a very good neighborhood.
cbrick
12-07-2012, 10:19 AM
If you can slug the bore but .310" would probably be a safe bet.
I always slug the bore just because curious minds need to know. That's a good thing with my 30-30, it has a great bore, clean sharp rifling from one end to the other with no loose or tight spots. It also has a .310" groove diameter from one end to the other. It shoots great as long as I pay attention to as cast diameters. Just goes to show ya that there are variations, everything is not always as it should be.
Rick
calgunner
12-10-2012, 05:13 AM
I would suggest you slug your barrel. With my 1917 30-06 Remington after I did this the bore and groove measured .302x.312. What I use for this rifle is Accurate Mold's 314299 that drops a 199 gr .303x.314 bullet.
Bruce
Have you tried to shoot them as cast? it might surprise you.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.