PDA

View Full Version : Bullet Kote



leftiye
09-30-2012, 06:08 PM
Anybody know anything about this stuff?

leftiye
10-01-2012, 02:31 AM
I googled it. Sells for about $20 for 16 0z. Can be airbrushed on or dipped. They recommend pre heating boolits before spraying but mainly to speed drying. They also recommend aking at 325 degrees to set and harden the coating.

375RUGER
10-01-2012, 08:34 AM
Don't think it was called bullet kote only moly kote before. I dipped some commercial cast boolits in it. I melted off the less than adequate lube first. I had no lead fouling after shooting a bunch that I loaded up. These same boolits foul really bad the way they came.

Their KG12 big bore cleaner is the best I've used for removing copper fouling.

Their coatings are very good. I have a few cans on hand in various colors.

leftiye
10-02-2012, 12:27 AM
Googled their home page and did some research. Boolits need to be real clean, acetone, brake cleaner, lacquer thinner clean. Surprisingly they've been making the stuff since the 70s. I got a can. Ironically, I'm considering not using moly because of Geargrinder's thoughts on the stuff. I've used Bullet Master since the 80s though and never had a problem. I actually found a can of Bullet Master recently on evil bay. Ya just gotta know that I just have to give it a try!

Sandstrom 28A (hope I got it right) is supposed to be about the same stuff.