Looking to try some 429421 and 429640

[Stick_man]

I am trying to decide on a mold for my .44 and am very interested in the 429421 (NOE) and the 429640 (MP). If somebody could spare a few to try, I would be most grateful. About all I have to offer up in trade is some raw wheelweights, .358 boolits, or some range brass.

Thanks

[redneckdan]

I have the 429640. Currently sized and lubed at .434 I could squish them down to .430 in a lee die if needed. Whatch ya got for range brass?

[swamp]

I have the Lyman 429421. Right now all I have are as cast. What size do you need?

swamp

[Stick_man]

The range brass I have is mostly 9mm or .40S&W and a few .45acp. I just picked up this .44 (Dan Wesson) and haven't had anything yet to slug it with, but am guessing I will be able to use .431 or .432. Hopefully I will be able to get it slugged this weekend.

[jabo52521]

Got plenty on hand of 430"s. Will be pleased to send you some.

[Stick_man]

Thanks guys for the offers. I recently was able to finally get the bores slugged and they came out right at .429 (according to my dial calipers). So, .430 or maybe .431 should work well. I am now mostly interested in the 429421 as I am in on the NOE group buy for that one.

I picked up some additional trade fodder if needed as well. I now have available some raw wheel weights, cast ingots of SOWWs, .40s&w brass, commercial .358 WCs, 9mm range brass, and maybe even some .357mag brass (very limited qty though).

[94Doug]

I also have a round groove '421 that Buckshot has HP'd...and a RCBS 250K, Lyman sq groove plain too.

d