Jim Flinchbaugh
01-05-2012, 11:30 PM
So I'm starting the sizing / lubing process of the 314299's and I am a little bit impatient waiting for the 450 to warm up, so I try and "stuff" a little lube in by turning the wrench harder, SNAP!
no more resistance, uh oh.:confused:
Unbolt it from the bench take it apart and find I have removed the head from the lube feed screw, (under the bottom).
Oh well, a little silver solder and a few seconds on the lathe and I'm back to waiting for the heater to catch up:veryconfu
(it apparently had been repaired once before from the looks of the brazing in there)
So the question is, what bone head moves have ya'll pulled lately?
Come on, fess up, we've all pulled a boner on occasion :killingpc
no more resistance, uh oh.:confused:
Unbolt it from the bench take it apart and find I have removed the head from the lube feed screw, (under the bottom).
Oh well, a little silver solder and a few seconds on the lathe and I'm back to waiting for the heater to catch up:veryconfu
(it apparently had been repaired once before from the looks of the brazing in there)
So the question is, what bone head moves have ya'll pulled lately?
Come on, fess up, we've all pulled a boner on occasion :killingpc