Rcbs

[shotman]

new for them
got a factory mold and it would not close. took 2 hrs to hone the line up pin holes to get it to close. Hope they dont go to Lees trash

[War Eagle]

Out of curiosity, did you call them? RCBS has an amazing customer service reputation. If it was a new mold, I am sure they would have helped you out.

[Hardcast416taylor]

I would have been on the horn to where I got it from to send it back, secondly I would have been on the horn to RCBS about it.Robert

[cbrick]

I guess anybody can mess up, even RCBS. The last new mold I got is the RCBS 22 55 gr, it is without doubt one of the best, easiest casting molds I have of over 70 molds. The mold really is a gem.

I would call them, if there is a problem it will be very difficult to fix if they don't know about it.

Rick

[220swiftfn]

new for them
got a factory mold and it would not close. took 2 hrs to hone the line up pin holes to get it to close. Hope they dont go to Lees trash

My 45-270-saa just needed the pins tapped in a little, did you try this first??


Dan

[shotman]

Well time I messed with sending it back I fixed it . It works now . Some lapping compound on the pins and working it back and forth set them. Took about 10 min to flat file a Lee handle to fit .
Kroil and cast about 100 nice 150gr 270 boolits
Lost about 20 before got mold to running temp
need to hone bottom of sprut plate it is a little rough