View Full Version : Looking for: 200gn .401cal hollow point mould

07-28-2011, 11:23 PM
Does anyone know of a 200+ grain hollow point mold for 10mm? Only thing I've seen so far would be to pay a fortune for a conversion of a non-hp mold.

All thoughts or suggestions welcome! Thanks.

07-29-2011, 05:16 PM
Anybody? Figured if anyone would know it would be you guys.

Wayne Smith
07-30-2011, 02:01 PM
Buckshot does not charge "a fortune" to HP a mold. I know this from experience. I don't believe Eric does either.