View Full Version : RCBS lube a matic.....the first one.
FORKLIFT352
07-23-2011, 01:42 AM
I got a RCBS and Lymen lube sizers.
Right now (being new) I'm rolling with
the RCBS....but not the #2.
Would the top punch and dies for #2
fit #1 ?
I got them from a garage sale and they
will need some parts and a good cleaning.
I would think I could get parts from RCBS...?
But what would clean old wax off?
Thanx for any help.
Huntducks
07-23-2011, 02:29 AM
Heat the wax with a propane torch on low or a blow dryer.
Have fun...
FORKLIFT352
07-23-2011, 04:59 AM
Would Lube a matic #2 top punch and sizing
dies fit the old lube a matic???
NoZombies
07-23-2011, 07:33 AM
Yes, the "new" punches will fit the older machine.
Good luck!
Disassemble it -- as far as you can with the lube still in it -- and boil it for about 15 minutes. Remove from the heat and allow the old lube to harden, which might take a few hours, then it can be pulled off (save for future use?) and then you can remove the components.
Use a dedicated, non-cooking utensil.
Calamity Jake
07-23-2011, 12:27 PM
I do the same as 462 but I pour off the lube when all is melted and floating on top then
I can remove the lubesizer from the water blow it of with compressed air and let the heat dry it out.
Calamity Jake ,
Never thought to pour off the water...a better idea. Why wait for the lube to harden when you could be working on the lubrisizer?
FORKLIFT352
07-24-2011, 01:37 AM
Thanx folks...I got it all taken apart and cleaned.
I used dentel picks and gun scruber.
And in some places a torch.
When I cleaned the dye wouldent you know....
it was for the .45 230 gr. Round nose...
Just what I needed!!!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.