PDA

View Full Version : Handgun Hangers


Jal5
06-02-2011, 04:07 PM
To expand your room for handgun storage in the safe has anyone tried these "handgun hangers"?
http://www.uniquetek.com/site/696296/product/T1328

I could totally rearrange my safe to fit the rifles better without using the right side with small shelves as I currently do for the handguns, if I had space for the handguns hanging from the topshelf.

Anybody had any experience with these?
Thanks
cabezaverde
06-02-2011, 04:59 PM
I mounted a piece of pegboard using standoffs on the inside of my safe door. Using rubber coated pegboard hooks, I keep all of my handguns on the door.
troy_mclure
06-02-2011, 07:51 PM
i have 5.11 Velcro holsters , they come with a sheet of velcro. i screwed the velcro sheets onto the door of my gun cabinet. i have 9 handguns down the door, saves tons of space. i think they ran $9/each.
Cherokee
06-03-2011, 05:51 PM
I've seen those before, looks like they would work fine.
crabo
06-03-2011, 10:59 PM
If I wanted those hangers, I would make up a jig to bend them, buy some rod, and some plastic tubing to go over the end. You could make a whole bunch more.
Bogart
06-04-2011, 09:38 AM
I bought a set of these, they are a little flimsy and I was hesitant to leave my handguns on them, but after about 2 months they are holding up fine, they are a little pricey though. The rifle rods they sell are a great idea and I really like them, they worked great cleaning up my safe.
deltaenterprizes
06-04-2011, 09:43 AM
Welcome to the forum Bogart!
Jim
06-04-2011, 09:46 AM
BOGART!! Welcome, buddy!
By the way, Bogie is my favorite "tough guy" actor.
HeavyMetal
06-04-2011, 10:34 AM
Nice idea just not convinced that putting a steel rod, and I don't care what it's coated with, down my bore is a good idea.

Worn muzzle affects accuracy.

I glued furniture grade plywood to the walls of my safe and drilled for wooden pins to hold the pistols flat against the wood surface. added plenty of room, looks nice with a light finish and won't damage the bore.
troy_mclure
06-05-2011, 10:04 PM
got a heat gun or propane torch? get a 10 pack of plastic hangers($1) and heat and shape to fit.
to might need to sand them down if smaller than 9mm.
captaint
06-05-2011, 10:48 PM
I did the pegboard on the door thing. Hang them on hooks. This is a great idea, though. I also like the plastic hangers deal. Mike
Ickisrulz
06-06-2011, 04:53 PM
If you haven't check this stuff out:

http://www.storemoreguns.com/