lyman load data?

[XWrench3]

there is a load in the lyman cast bullet book for 44 special using IMR SR4759 powder (11.9-13.4g). has anyone ever used this load? i have not seen SR4759 used in a pistol load before. and before i blow up my S&W, i want to make sure it is not a typo! i checked online @ hodgedon.com, but they do not list a load using it. i normally use the SR4759 for reduced power rifle loads.

[peerlesscowboy]

I haven't used it but it looks reasonable to me, doesn't look like a typo.

[Larry Gibson]

Lyman #3 lists the 4759 load. They list it and 4756 with 3 different bullets so my assumption would be it is correct. 4759 is a slower burning powder than 2400 and the charges listed are fairly close so it seems safe to me. As always start at the "start load" and work up.

Larry Gibson

[KYCaster]

My RCBS CB Manual #1 lists 11.5 to 12.5 of SR4759 and also 6.0 to 7.0 of SR4756, with their 44-250-SWC.

I doubt very much if it's a typo since they're both on the same page with the same boolit.

Jerry

[Guesser]

I have used 4759 in 44 Magnum, it worked OK, but not great. I got my magnum data from an old DuPont powder brochure from the early 70's. I just looked at the same load guide and they don't give a recommendation for 4759 in 44 Special. I would be surprised if you get a good burn at Special pressures and a hand gun barrel.