Interesting 9mm

[Blammer]

I was fortunate enough to get to borrow a 4C Saeco mould from a fellow caster/board member here. This is the projectile it tossed out.

.357 dia
WW alloy air cooled
wt of 115gr

http://i54.photobucket.com/albums/g81/blammer8mm/Cast%20boolits/9MM/DSCN8376.jpg

anybody have this or use it?

[3006guns]

Looks like something from the Civil War..........:)

Nope, I've never seen a mold like that.

[shotman]

will it feed???? I bet it dont on some 9s would be good to try do you have about 20 I could try in a sig

[Blammer]

don't know if it will feed or not, i'll have to load up a dummy rnd and try it out.

[Artful]

reminds me of the group buy 135 grain sllippery 9mm that MakeMineA10mm ran
http://castboolits.gunloads.com/attachment.php?attachmentid=4952&stc=1&thumb=1&d=1251127025
http://castboolits.gunloads.com/attachment.php?attachmentid=8742&stc=1&thumb=1&d=1251127405

[CWME]

Blammer is that the #922?

[BarryinIN]

I've looked at the 922 (and that's what it looks like) and it looked interesting, but the shoulder is a lot more pronounced than I expected from their drawing. Wow.

[Blammer]

yes it is, I looked Saeco 922 and below it FF4

ran two through my sizer .357 dia, didn't touch the sides of the boolit but lubed it well. I then loaded the two behind 5gr of unique and shot them.

they fed and fired and ejected just fine out of my Baretta 92FS.

I deformed the nose a bit with the top punch I was using and then a bit more with the seater. I think they will be fine.

[6.5 mike]

A 9m/m collar button ? [smilie=l:

[thx997303]

Looks like a fat nosed himelwright boolit dj.

[MtGun44]

'spect it will feed nicely. Cutting shoulder to make targets look nice, probably a target
9mm or .38 Super boolit.

Bill

[LowPE]

a little light for 38 super I think.

I have the rcbs target 9 -- similiar design but a little heavier at 124. The rcbs feeds fine and leaves beautiful holes for scoring.