Saeco nose punch and RCBS 82154?

[Ola]

Please help me.

What Saeco Lubrisizer nose punch is the best for RCBS 82154 .357-180-SILH 430?

https://shop.rcbs.com/WebConnect/MainServlet?storeId=webconnect&catalogId=webconnect&langId=en_US&action=ProductDisplay&screenlabel=index&productId=3382&route=C12J059

I've contacted Redding / Saeco and got no answer. The local distributor of Redding / Saeco could not help me and I don't seem to be able to find any information about this in the WWW either.

Thank you very much,

Ola

[Calamity Jake]

Please help me.

What Saeco Lubrisizer nose punch is the best for RCBS 82154 .357-180-SILH 430?

https://shop.rcbs.com/WebConnect/MainServlet?storeId=webconnect&catalogId=webconnect&langId=en_US&action=ProductDisplay&screenlabel=index&productId=3382&route=C12J059

I've contacted Redding / Saeco and got no answer. The local distributor of Redding / Saeco could not help me and I don't seem to be able to find any information about this in the WWW either.

Thank you very much,

Ola

Saeco TP #35353 or 35311 both are for 38/357 FP boolits
should work just fine.

If you know a machinest in your area, take him any Saeco TP, have him duplicate the hex portion up then bore a hole to fit the
Lyman/Rcbs TPs have him keep the hex as short as possible.

[Humbo]

Ola, check this site out: http://www.hollowpointmold.com/specialty-screws/

Scroll down until you see "Saeco : Top punch adaptor", I just ordered one myself.

[Ola]

Thanks!

But as Calamity Jake Said,"If you know a machinest in your area.."

[theperfessor]

I carry Saeco-compatible nose punches that you custom fit to your exact bullet. See my sig line below