Processed a little brass today

[grubbylabs]

Guess I need to cast a few more boolits. I sized, trimmed and primed 360 pieces of brass today, now not only am I out of large pistol primers now but my hand hurts from the hand priming tool

[runfiverun]

get another one and use both hands....:lol:

[grubbylabs]

get another one and use both hands....:lol:


Then I can't load the brass in the priming tool.

[lwknight]

And I thought that I was a sucker for a cheap shot.:bigsmyl2:

[geargnasher]

Nah, here's the cheap shot: You actually trimmed .45 ACP brass? Why? They make trimmers for those? :kidding:

Gear

[grubbylabs]

I had to trim it, my XD is a little fussy about brass length. And to think I only have a few hundred more.

[geargnasher]

I'm surprised, that would be one of the very few "factory" (NOT custom match) chambers I've heard of that weren't 10-15 thousandths over service length of the brass. That's actually a good thing, since it will allow your brass to actually headspace on the case mouth instead of the boolit or the extractor claw.

Gear